Friday, October 4, 2013

Getting Ready

We routed the inside of the stem with a round over bit.
After priming the floorboards of skiff #1, we scuffed the floorboards with fine grit sandpaper.  Scuffing will allow the top coat of paint to stick.

Rolling the top coat of non-skid on the floorboards for skiff #1 (on the left).  
Now that the plywood pads are glued to the floor, we double-checked with the water level before we permanently fasten the legs of the strong back to the pads.

It's levelled, so we are fastening it down!

No comments:

Post a Comment